# High ping spikes with OpenWrt in Proxmox — retained record

> Retained reddit record from reddit:homelab.

Canonical: https://highsignal.app/data/records/5abcbe2180af5008

[← sources](https://highsignal.app/data)


source: [reddit](https://highsignal.app/data/reddit) (reddit:homelab)  published 2026-10-19 22:06 ingested 2026-10-20 02:39

[original source ↗](https://www.reddit.com/r/homelab/comments/1xaama3/high_ping_spikes_with_openwrt_in_proxmox/)

## retained text



```
Hey everyone,

I'm troubleshooting a networking issue in my homelab and would appreciate some advice on identifying the actual bottleneck.

**My setup:**

* **Fiber ONT:** Unfortunately, it doesn't support bridge mode. I've disabled its DHCP server and assigned a static IP to the Proxmox host.
* **Proxmox:** Runs OpenWrt as a VM and passes the network interfaces through Linux bridges.
* **OpenWrt:** Acts as my main router, handling NAT, firewall, DHCP, and the LAN.
* **ZTE H188A:** Connected to OpenWrt and used only as a Wi-Fi access point and Ethernet switch. Its DHCP server is disabled.

The network works, but I'm experiencing severe latency spikes when pinging `8.8.8.8`.

Here is an example from my phone:

* Average ping: **241 ms**
* Maximum ping: **977 ms**
* Packet loss: **6.3%**

Normally, the latency can be around 40–50 ms, but occasionally it suddenly jumps to hundreds of milliseconds.

**The most interesting part is that the issue is much worse on Wi-Fi devices connected to the ZTE H188A.** Devices connected through the ZTE's Ethernet ports experience significantly smaller spikes.

My main suspect is the **cheap 100 Mbps USB-to-Ethernet adapter** I'm using for one of the Proxmox network interfaces. I'm wondering whether it could be causing packet drops, latency spikes, or some kind of bottleneck.

However, I'm not sure whether the problem is actually caused by the adapter, Proxmox bridges, OpenWrt configuration, the ZTE's Wi-Fi, or the fact that the ONT is still routing instead of operating in bridge mode.

**What would you check first, and how would you isolate the cause?** Would replacing the USB-to-LAN adapter with a proper Gigabit Ethernet adapter be a reasonable first step, or should I run some specific tests before buying anything?

Thanks!
```



document fetched 2026-10-20 00:36 · canonical https://reddit.com/r/homelab/comments/1xaama3/high_ping_spikes_with_openwrt_in_proxmox
