# Is my motherboard borked? — retained record

> Retained reddit record from reddit:homelab.

Canonical: https://highsignal.app/data/records/5f48c4e5eb99c44c

[← sources](https://highsignal.app/data)


source: [reddit](https://highsignal.app/data/reddit) (reddit:homelab)  published 2026-10-31 17:26 ingested 2026-11-01 02:39

[original source ↗](https://www.reddit.com/r/homelab/comments/1xkg1pf/is_my_motherboard_borked/)

## retained text



```
I am fighting my newly aquired ASRock Rack ROMED8-2T to try and boot into BIOS. The full setup would technically:

- CPU: Epyc 7343
- RAM: 4x 32GB -> 128GB, DDR4
- GPU: 2x ASUS variant of the Radeon AI Pro R9700
- SSD: A random flikwood SSD I found on ebay lol. 1TB.

But, this has not gone great so far. The Arctic Freezer I bought snapped a spring when I was just trying to dismount it to reseat the CPU and no matter how many RAM sticks I use or where I put them, I end up at the same result: The segment display goes through and stays stuck at `16`, which seems to be memory training. But even a whole hour later, it's still there...I went to take a shower and just let it sit in hopes that would do anything.

I have stripped the system all the way down to just the NVMe, a single stick of RAM and CPU. Even updated the BIOS, too, using the BMC - because that one works just fine. I also checked the pins on the board and the CPU's bottom and they both seem good.

Pictures:

[image.png](https://postimg.cc/2bPxPqN7)
[image.png](https://postimg.cc/2bPxPqN7)

I replaced the broken cooler with a Dynatron for now - which helps because being a little smaller but louder means I actually get access to the two inner memory channels, which the Arctic had previously fully covered. So that actually helps.

I am very much stuck here. Dozens of CMOS resets and all and nothing seems to move anything. So I am going to order a serial to usb cable - because the one I had previously has a female plug (and is attached to an RS232 to RJ45 adapter that I use to plug into my OPNSense running on a Sophos SG330) and also a VGA to HDMI cable to see if ANYTHING appears ANYWHERE.

If you have recommendations or ideas (according to Qwen, the board is known to have quirks as posted on the level1techs forum), please let me know. I just want to get this rig working and having almost been hit by a flying spring and screw was... not fun. XD
```



document fetched 2026-11-01 00:33 · canonical https://reddit.com/r/homelab/comments/1xkg1pf/is_my_motherboard_borked
