In-wall Cat6 conduit touches 230V AC conduit for ~24" at corner bend. Am I overthinking 2.5G/10G interference? (Pics)
retained text
Renovated my apartment where the brick/masonry is already plastered & painted . Two Cat6 cable runs in each PVC conduit (6 total). Reviewing construction photos and confirming it with electrician, I found one corner where the Cat6 conduit directly touches an existing 230V conduit (powers a fridge (now), 2-ton inverter AC (next year) and few lights, charging points etc.) for about **18\~24 inches** before diverging. The cables are Finolex Solid 23 AWG unshielded pure copper Cat6 UTP and the lowest CAT6 conduit (that touches the 230V electrical conduit) runs 72 ft (22 m) total. I tested connecting a gigabit ONT to my laptop over both cables in this run and the link negotiates at 1000/1000 Mbps but I know auto-negotiation is only the bare minimum test of a proper Ethernet installation. I plan to upgrade to 2.5G next year and test 10G later. Is this setup going to hold up fine, or am I royally screwed?
document fetched 2026-09-20 00:33 · canonical https://reddit.com/r/homelab/comments/1wkjunv/inwall_cat6_conduit_touches_230v_ac_conduit_for