← sources

Cubic Doggo 07B Wouf: A low-budget open-source quadruped robot with smart servos

source: reddit (reddit:robotics)published 2026-10-30 00:17ingested 2026-10-31 02:39

retained text

Phew, it's finally complete, even though the turning gait still lacks optimization. 

**Cubic Doggo 07B Wouf** is a ROS2-controlled 12-DOF untethered quadruped, built with ST3215 smart servos and fully with off-the-shelf components and 3D-printed parts

GitHub: [https://github.com/SphericalCowww/CubicDoggo\_07B/tree/main](https://github.com/SphericalCowww/CubicDoggo_07B/tree/main)

\-----------------------------------------------------------------

Featuring (or some blah blah from me):

* 12 ST-3215-C018 servos, usually on a bundled sale because of SO-ARM101
* Walking forward with a payload of 1 kg
* Smart servos are required for closed-loop reinforcement learning capability (if the read latency issue is fixed, that is)
* FreeCAD models are fully available for editing
* M3 screws and locknuts are used extensively (instead of glue or heat set inserts) to strengthen and secure the PLA+ printed structures (quite a pain in the neck to install, though). Design iterates on strengthening whichever part breaks first.
* No custom PCB (because I am terrible at it), only 2 required soldering points
* Walks on batteries; the stand stance lasts 4hr and still going!
* Runs on a Raspberry Pi with ROS2 Jazzy installed. Joystick control ready
* Aesthetics of an exposed electronic box, but great as a development platform for stacking new components on top

Thanks to all the comment/advice on Reddit, that made a lot of these possible!

Next steps are to solve the read latency, implement IMUs, optimize gait, and make Wouf carry more things.

document fetched 2026-10-31 00:40 · canonical https://reddit.com/r/robotics/comments/1xj0ul9/cubic_doggo_07b_wouf_a_lowbudget_opensource